
Furnace Installation in Montgomery, AL
AFUE in plain words, right size, dual-fuel where it fits. Get a written quote before any work starts.
- ✓21-point audit in full
- ✓Call direct, no forms to fill
- ✓Serving Montgomery, Prattville & Wetumpka
ANSWER FIRST
Do you need a new furnace?
You need a new furnace when repairs keep stacking up, the furnace cannot keep up on a cold night, or the repair price sits close to half the replacement price. The decision comes from your written quote, not from age alone. A cracked heat exchanger is the fault that ends the repair conversation, because it is a core fault found by a technician inspection.
Montgomery winters are mild, with a January low near 37 degrees, but cold snaps drop to 14 to 18 degrees, and there are about 37 freezing nights a year. A new furnace has to handle those coldest nights, not just the average winter day. That is why sizing uses the design heating temperature of 27 degrees, and why dual-fuel is worth a look in the next sections.

AFUE
What is AFUE, and which type fits your home?
AFUE, Annual Fuel Utilization Efficiency, is the share of the fuel that becomes heat in your home. A furnace rated 80% AFUE turns 80 cents of every fuel dollar into heat, and the rest leaves through the flue. A furnace rated 95% AFUE turns 95 cents into heat. The rating is measured in a lab, so your ductwork and your house still change the result.
There are two types. A non-condensing furnace vents hot exhaust through a metal flue, and the federal minimum for a new non-weatherized gas furnace is 80% AFUE, in force since 2015. A condensing furnace pulls extra heat out of the exhaust, vents through plastic pipe, and typically runs near 90 to 98% AFUE. Condensing furnaces cost more up front, and they need a drain for the water they condense out of the exhaust.
Do not take 95% AFUE as today's minimum. The federal rule that would have set 95% AFUE as the minimum for furnaces built after December 2028 is unsettled: the Supreme Court vacated the lower court ruling in June 2026, and the Department of Energy has sought comment on delaying it. The minimum in force today is 80% AFUE. A quote that presents 95% as the current minimum is wrong.

| Furnace type | AFUE range | What it means for your home |
|---|---|---|
| Non-condensing gas furnace | 80% AFUE, the federal minimum | Vents through a metal flue, lower upfront cost, more heat lost up the flue |
| Condensing gas furnace | About 90 to 98% AFUE | Pulls extra heat from the exhaust, vents through plastic pipe, needs a condensate drain |
| ENERGY STAR gas furnace, South | 95% AFUE | The ENERGY STAR bar for the South, higher than the federal minimum |
Which type fits your home depends on the flue you have and the drain you can add. Ask for both types priced on the same quote, with the venting and drain work named.
SIZING
What size furnace do I need?
The size comes from an ACCA Manual J load calculation, room by room, for your house as it stands today. It measures heat loss through walls, windows, roof, and air leakage, and it uses the Montgomery design heating temperature of 27 degrees. No fixed tons-per-square-foot rule gives the right answer, because two houses with the same floor area can lose heat very differently.
An oversized furnace short cycles, starting and stopping in short bursts that leave rooms uneven and wear the equipment. An undersized furnace runs without stopping on the coldest nights and never reaches the set temperature. The right size holds the house steady through a 27-degree night without constant cycling.
Ask to see the load calculation with your quote. It should list the design temperature, the room-by-room loads, and the furnace size it points to. If a quote gives a size with no calculation behind it, ask how the size was worked out. Our page on furnace repair in Montgomery explains how the repair price and the replacement price sit side by side, so the two rules work from real figures.

DUAL FUEL
What is dual-fuel, and is it right for Montgomery?
Dual-fuel pairs a heat pump with a gas furnace. The heat pump heats the house in mild weather, and the gas furnace takes over when the temperature drops below the point where the heat pump can keep up. One thermostat runs the switch.
Montgomery is a good fit for dual-fuel. Most winter days are mild, so the heat pump carries the house most of the season, and the furnace covers the cold snaps down to 14 to 18 degrees. Homes that already have a gas line are the natural fit.
Dual-fuel is not right for every home. A home with no gas line needs a new gas connection, which adds cost. Our page on heat pump installation in Montgomery covers the heat pump side.

QUOTE
What should a good quote include?
A good quote is a written price before work starts, and it names everything the job includes. Ask for the equipment make and model, the size from the load calculation, the AFUE rating, the venting and flue work, the condensate drain for a condensing furnace, the gas line work if any, the electrical work, the permit, and removal of the old furnace. Each item should be named, not folded into one line.
The quote should also name the thermostat that comes with it, and whether the thermostat can run a dual-fuel changeover if you choose that option. If ductwork changes are needed, they belong on the quote too, with the reason given in plain words. A quote that leaves the permit out, or the old-furnace removal out, is not complete.
Compare quotes on the same list. Two quotes for different AFUE ratings, different sizes, or different included work are not the same job, and the cheaper one may simply leave more out.

INSTALL DAY
What happens on install day?
Protect and Remove
The work area is protected, the gas and power are shut off, and the old furnace is disconnected and removed from the house.
Set and Connect
The new furnace is set in place, the gas line, venting, and drain are connected, and the electrical work is finished.
Test and Check
The system is started and run through a full heating cycle. The technician checks the burners, the flame, the airflow, the safety controls, and the venting.
Walkthrough
The technician walks you through the thermostat, the filter location, and what to watch for in the first days. The written price agreed before work is the price that stands.
Most standard installs finish in a single day. Homes that need venting changes, gas line work, or ductwork changes can take longer, and the quote should say so before work starts. No time guarantee belongs on a quote, because the house decides how long the job takes.
At the end of the day the furnace should run a full heating cycle with hot air at the vents and the safety controls working. If not, say so before the technician leaves.

Before and after: furnace installation in Montgomery

BeforeAfterillustrative examples only
Before and after: furnace installation, second example

BeforeAfterillustrative examples only
PERMIT
Do I need a permit to install a furnace in Montgomery?
Yes, a furnace replacement needs a mechanical permit from the City of Montgomery Inspection Department, at 25 Washington Ave, phone 334-625-2073. The installer pulls the permit, and the work follows the 2024 International Mechanical Code. The permit covers the equipment change, and an inspection follows the install.
The published fee schedule, as of 10/31/24, starts with a base fee of $50. Heating coils are $3 each, thru-wall units are $7 each, and duct work carries no charge. The first re-inspection is free, the second costs $25, and the third and later cost $50 each. Work that starts before the permit is issued costs a fee equal to 100 percent of the original permit fee.
Ask for the permit on your quote. A quote that names the permit, and the inspection that follows it, is a complete quote.

READY
What to have ready when you call
Have these five details handy when you call.
- Current furnace: brand, age, and AFUE rating if you know it, from the label on the unit.
- What failed: the fault the technician named, and whether the repair price is close to half the replacement price.
- Gas line: whether the home already has gas, and where the gas meter sits.
- Venting: whether the current furnace vents through a metal flue, and whether a drain route exists for a condensing furnace.
- Rooms that never warm: which rooms lag behind on cold nights, and whether the house has a heat pump already.
QUESTIONS
What do Montgomery homeowners ask about furnace installation: cost, AFUE, and dual-fuel?
It depends on the size from the load calculation, the AFUE rating, the venting, the gas line work, the ductwork, and the permit. A condensing furnace costs more up front than a non-condensing one. Ask for a written quote that names each item, so two quotes can be compared on the same list.
Most standard installs finish in a single day, from removal of the old furnace to testing the new one. Homes that need venting changes, gas line work, or ductwork changes can take longer. The quote should say so before work starts. No time guarantee belongs on a quote.
AFUE is the share of the fuel that becomes heat in your home. A non-condensing furnace meets the 80% federal minimum and vents through a metal flue. A condensing furnace runs about 90 to 98% AFUE, vents through plastic pipe, and needs a drain. Your flue and drain route decide which fits.
Dual-fuel pairs a heat pump with a gas furnace. The heat pump heats in mild weather, and the furnace takes over on cold snaps. Montgomery fits well, because most winter days are mild and cold snaps drop to 14 to 18 degrees. Homes with a gas line already are the natural fit.
The size comes from an ACCA Manual J load calculation, room by room, using the Montgomery design heating temperature of 27 degrees. No fixed tons-per-square-foot rule gives the right answer. Ask to see the calculation with your quote, with the room loads listed.
Yes. A furnace replacement needs a mechanical permit from the City of Montgomery Inspection Department, at 25 Washington Ave, phone 334-625-2073. The installer pulls the permit, and the work follows the 2024 International Mechanical Code. Ask for the permit on your quote.

CALL NOW
New furnace in Montgomery: AFUE, sizing, and dual-fuel, all on one written quote
New Furnace Quote? Call With Your Load Calculation
We size from a room-by-room load calculation, name the AFUE rating, and pull the permit. The price comes in writing before any work starts.
Repair or Replace? Work It From Your Written Quote
On our page about furnace repair in Montgomery, the two rules, age times repair cost against $5,000, and repair cost against half the replacement cost, worked from real figures.
Homeowners describe this job in different words: furnace installation Montgomery AL and furnace replacement Montgomery AL all mean the same sized quote, with the same written price before work.
Not sure the furnace is the problem? Start with a repair visit, and let the written quote decide whether repair or replacement is the smarter move.
- Furnace not heating? Our guide to a furnace with no heat covers the thermostat, filter, and ignition checks first.
- A finished install is on our projects page, before and after.
- The same install process and written-price rule apply in Prattville homes and Wetumpka homes, one rule for three cities.

Find us
Furnace installation in Montgomery: our Prattville base
Our base is at 714 E Main St, Prattville, just off I-65 from Montgomery. Call (334) 555-0142 for a written quote, and the technician comes to you. The same install process covers homes in Montgomery, Prattville and Wetumpka, with the same written price before work.
- Areas served: Montgomery, Prattville and Wetumpka, with the same visit process in each city.
- What to have ready: the symptom, when it started, and the system brand and age if you know it.
- How the visit works: the technician comes to your home. This address is the base the visit starts from.
Cloverdale HVAC 714 E Main St, Prattville, Alabama 36067, USA (334) 555-0142