A new heat pump being installed at a home in Montgomery, AL

Heat Pump Installation in Montgomery, AL

One unit that heats and cools, sized for Montgomery summers and winters.

  • ✓21-point audit in full
  • ✓Call direct, no forms to fill
  • ✓Serving Montgomery, Prattville & Wetumpka

Published by the team at Cloverdale HVAC

ANSWER FIRST

Is a heat pump right for your home?

For most Montgomery homes, yes. A heat pump heats and cools from one outdoor unit, and Montgomery winters are mild enough that it carries the house most of the season. The same unit that cools you through a 93-degree summer heats you through a mild winter. A gas furnace still makes sense if you already have a gas line, or if you pair it with a heat pump as a dual-fuel system.

The decision turns on your fuel options, your ductwork, and how you like your home to feel. Heat pump air feels warm, not hot, and the system runs longer cycles to make up for it.

A heat pump outdoor unit running on a winter morning in Montgomery, AL
A heat pump on a winter morning: warm, not hot, air in long steady cycles.

SIZING

What size heat pump do I need?

The size comes from an ACCA Manual J load calculation, room by room, for your house as it stands today, using Montgomery design temperatures: 93 degrees dry-bulb and 76 degrees wet-bulb in summer, and 27 degrees in winter. No fixed tons-per-square-foot rule gives the right answer.

Cooling governs the load in Montgomery. The system is sized on the summer side, because the cooling load is the bigger one here. A heat pump sized only for winter would be far too big for summer, and it would short cycle, leaving the house cold but clammy.

Ask to see the load calculation with your quote. It should list the design temperatures, the room-by-room loads, and the equipment size it points to. If a quote gives a size with no calculation behind it, ask how the size was worked out.

An HVAC technician measuring a home during a load calculation for a new heat pump in Montgomery, AL
A load calculation measures each room before any size is named.

RATINGS

What is SEER2 / HSPF2 for a heat pump?

A heat pump carries two ratings, because it does two jobs. SEER2 is the seasonal cooling efficiency rating, and HSPF2 is the seasonal heating efficiency rating. A higher number means the system uses less electricity for the same heating or cooling over a season.

The minimum for a new split-system heat pump is 14.3 SEER2 and 7.5 HSPF2, nationwide. A single-package heat pump must meet 13.4 SEER2 and 6.7 HSPF2. Systems above the minimum cost more up front.

Do not judge a quote by the ratings alone. A high SEER2 on a wrongly sized system still short cycles, and a right-sized system with sound ductwork beats a bigger number on a poor install.

An old heat pump outdoor unit beside a new high-efficiency heat pump in Montgomery, AL
An old heat pump beside a new one: compare ratings on the same sized quote.

WINTER

Will a heat pump work in a Montgomery winter?

Yes. Montgomery design heating is 27 degrees, and a heat pump sized for the house works through most of the winter. On mild days it moves heat from the outdoor air inside, and it delivers more heat energy than the electricity it uses.

As the outdoor temperature falls, the heat pump loses capacity, and below the balance point the aux heat makes up the difference. Montgomery cold snaps drop to 14 to 18 degrees, and on those nights the aux heat strips will run, and the electric bill will show it. That is the design working, not a failure.

Two details decide how well a heat pump does on a cold snap: the balance point, and the thermostat lockout setting. A lockout copied from a cold-climate default does not fit Montgomery.

A heat pump outdoor unit running on a cold snap morning in Montgomery, AL
A heat pump on a cold snap: aux heat makes up the difference below the balance point.

LATENT LOAD

Why does humidity decide the size?

An air conditioner and a heat pump in cooling mode do two jobs at once: they lower the air temperature, and they pull moisture out of the air. The moisture job is called the latent load, and in Montgomery it is the bigger part of the comfort problem, with summer humidity near 70 to 83 percent.

An oversized unit does the temperature job fast, so the thermostat is satisfied and the system switches off before the coil has dried the air. The result is a house that feels cold but clammy. Cooling the air without drying it is only half the job.

The fix is a right-sized system that runs in long, steady cycles, giving the coil time to dry the air and move conditioned air to the far rooms.

Moisture on the outdoor coil of a heat pump in Montgomery, AL
Humidity is the bigger comfort problem in Montgomery: the coil has to dry the air, not just cool it.

DUAL FUEL

What is dual-fuel?

Dual-fuel pairs a heat pump with a gas furnace. The heat pump heats the house in mild weather, and the gas furnace takes over when the temperature drops below the point where the heat pump can keep up. One thermostat runs the switch, and the changeover point is set for your house.

Montgomery is a good fit for dual-fuel. Most winter days are mild, so the heat pump carries the house most of the season, and the furnace covers the cold snaps down to 14 to 18 degrees. You get steady heat on the coldest nights without giving up the heat pump's mild-weather running. Homes that already have a gas line are the natural fit, because the furnace needs gas and a flue.

Dual-fuel is not right for every home. A home with no gas line needs a new gas connection, which adds cost. Our page on furnace installation in Montgomery covers the furnace side.

A dual-fuel system, a heat pump with a gas furnace backup, in a Montgomery, AL home
Dual-fuel: a heat pump for mild days, a gas furnace for cold snaps.

QUOTE

What should a good quote include?

A good quote is a written price before work starts, and it names everything the job includes: equipment make and model, size from the load calculation, SEER2 and HSPF2 ratings, line set, pad, electrical work, aux heat strip size, thermostat, permit, and removal of the old system.

The quote should also name the refrigerant, R-32 or R-454B for a new system, and the aux heat lockout setting. A quote that leaves the permit out, or the old-system removal out, is not complete.

Compare quotes on the same list. Two quotes for different sizes or ratings are not the same job.

An HVAC technician showing a written heat pump installation quote to a homeowner in Montgomery, AL
A written quote names the equipment, the size, the ratings, and the permit.

INSTALL DAY

What happens on install day?

Protect and Remove

The work area is protected, the old system is disconnected, and the refrigerant is recovered by the technician. The old unit is removed from the house.

Set and Connect

The new indoor coil and outdoor unit are set in place, the line set is run and connected, the drain is connected, and the electrical work is finished.

Charge and Test

The system is pressure tested, evacuated, and charged with refrigerant, then run in both heating and cooling to check airflow, temperature split, and the drain.

Walkthrough

The technician walks you through the thermostat, the filter location, the aux heat setting, and what to watch for in the first days. The written price agreed before work is the price that stands.

Most standard installs finish in a single day. Homes that need ductwork changes, electrical upgrades, or a gas line for dual-fuel can take longer, and the quote should say so before work starts.

At the end of the day the system should run a full heating cycle and a full cooling cycle. If not, say so before the technician leaves.

An HVAC technician finishing a heat pump installation in a Montgomery, AL home
A heat pump installation, tested in both heating and cooling before the technician leaves.

Before and after: heat pump installation in Montgomery

Before: an old heat pump outdoor unit before replacement in Montgomery, AL
After: the new heat pump outdoor unit installed in its place in Montgomery, ALBeforeAfter

illustrative examples only

Before and after: heat pump installation, second example

Before: a heat pump installation under way in Montgomery, AL
After: a new heat pump outdoor unit installed in Montgomery, ALBeforeAfter

illustrative examples only

REBATES

What rebates are open right now?

The Alabama Power heat pump rebate offers $1,000 for switching from a gas furnace to a high-efficiency all-electric heat pump rated 20 SEER or 18 SEER2 or higher, with the application made within 90 days. The programme ends December 1, 2026. Check the programme page before you rely on it.

Two other programmes are not open. The Alabama ADECA home energy rebates, HEAR and HOMES, have not launched, and no application is open. The federal 25C tax credit ended Dec 31, 2025, so a 2026 install gets $0 from it.

Spire runs a gas rebate programme, but the dollar figures are not verified, so this page names the programme only. Ask for the rebate in writing on your quote.

A heat pump and a gas furnace side by side in a Montgomery, AL home
A heat pump beside a gas furnace: the rebate covers a switch from gas to electric.

PERMIT

Do I need a permit to install a heat pump in Montgomery?

Yes, a heat pump replacement needs a mechanical permit from the City of Montgomery Inspection Department, at 25 Washington Ave, phone 334-625-2073. The installer pulls the permit, and the work follows the 2024 International Mechanical Code.

The published fee schedule, as of 10/31/24, starts with a base fee of $50. An air conditioning system up to 3 tons adds $10, over 3 to 5 tons adds $15, over 5 to 10 tons adds $18, and each ton over 10 adds $3. Heating coils are $3 each, thru-wall units are $7 each, and duct work carries no charge. The first re-inspection is free, the second costs $25, and the third and later cost $50 each. Work that starts before the permit is issued costs a fee equal to 100 percent of the original permit fee.

Ask for the permit on your quote. A quote that names the permit, and the inspection that follows it, is a complete quote.

A mechanical permit document for a heat pump installation in Montgomery, AL
The mechanical permit comes from the City of Montgomery Inspection Department.

READY

What to have ready when you call

Have these five details handy when you call.

  • Current system: brand, age, and size if you know it, plus the refrigerant type from the nameplate.
  • Fuel options: whether the home has gas, and whether you want a heat pump alone or a dual-fuel pair.
  • Rooms that never cool or never warm: which rooms lag behind.
  • Electrical panel: whether there is spare capacity for the aux heat strips.
  • What you want priced: repair and replacement side by side, so the two rules work from real figures.

QUESTIONS

What do Montgomery homeowners ask about heat pump installation: size, ratings, and winter performance?

Yes, for most homes. Montgomery winters are mild, so a heat pump carries the house most of the season, and the same unit cools through a long, humid summer. Cold snaps down to 14 to 18 degrees are the test, and the aux heat covers them.

It depends on the size from the load calculation, the SEER2 and HSPF2 ratings, the ductwork, the electrical work, and the permit. A higher rating or ductwork changes move the figure. Ask for a written quote that names each item.

Yes. Montgomery design heating is 27 degrees, and a heat pump sized for the house works through most of the winter. On cold snaps down to 14 to 18 degrees the aux heat strips make up the difference. That is the design working, not a failure.

The size comes from an ACCA Manual J load calculation, room by room, using Montgomery design temperatures of 93 degrees dry-bulb and 76 degrees wet-bulb in summer and 27 degrees in winter. Cooling governs the load here. No fixed tons-per-square-foot rule gives the right answer.

SEER2 is the seasonal cooling rating, and HSPF2 is the seasonal heating rating. A new split-system heat pump must meet 14.3 SEER2 and 7.5 HSPF2 nationwide, and a single-package heat pump must meet 13.4 SEER2 and 6.7 HSPF2. Higher ratings cost more up front.

A heat pump is the practical choice for most homes, because winters are mild and the same unit also cools through a long, humid summer. A gas furnace makes sense if you already have a gas line, or pair it with a heat pump as dual-fuel.

A homeowner talking with an HVAC technician about a new heat pump in Montgomery, AL
A homeowner talking with an HVAC technician about a new heat pump

Call With My Question

CALL NOW

Heat pump in Montgomery: one unit, sized for summer and winter

Call now

Heat Pump Quote? Call With Your Load Calculation

We size from a room-by-room load calculation and pull the permit.

Call For A Heat Pump Quote

Plan ahead

Repair or Replace? Work It From Your Written Quote

On our page about heat pump repair in Montgomery, the two rules worked from real figures.

Homeowners describe this job in different words: heat pump installation Montgomery AL and heat pump replacement Montgomery AL all mean the same sized quote, with the same written price before work.

Not sure a heat pump is the right fit? Start with a repair visit, and let the written quote decide.

An HVAC technician talking with a homeowner about a new heat pump in Montgomery, AL
An HVAC technician talking with a homeowner about a new heat pump.

Find us

Heat pump installation in Montgomery: our Prattville base

Our base is at 714 E Main St, Prattville, just off I-65 from Montgomery. Call (334) 555-0142 for a written quote, and the technician comes to you. The same install process covers homes in Montgomery, Prattville and Wetumpka, with the same written price before work.

  • Areas served: Montgomery, Prattville and Wetumpka, with the same visit process in each city.
  • What to have ready: the symptom, when it started, and the system brand and age if you know it.
  • How the visit works: the technician comes to your home. This address is the base the visit starts from.

Cloverdale HVAC 714 E Main St, Prattville, Alabama 36067, USA (334) 555-0142

Get Help NowServices